Commercial Glass Regulations by State
Building codes, energy codes, licensing and special glass rules for storefronts, curtain walls and entrances, state by state.
Last reviewed October 29, 2026
Home / State Regulations
Rules for commercial glass come from several places at once: the building code your city or state adopts, the energy code, accessibility rules, contractor licensing and, in some places, wind, impact or bird-friendly glass rules. Each state handles these differently. Some adopt one code for the whole state. Others leave it to every city and county.
Pick a state below for its current rules, with links to the official sources. City pages for key markets are coming next.
Choose a state
Arizona
Arizona leaves building and energy codes to each city and county. Here is how that shapes a storefront, curtain wall or entrance project.
Nevada
Nevada sets the energy code statewide and leaves the building code to local jurisdictions. Here is what that means for commercial glass.
New York
New York State and New York City run separate code systems. Here is how each one affects storefront, curtain wall and entrance glass.
Illinois
Illinois sets a statewide energy code but leaves the building code to local governments, and Chicago writes its own. Here is what applies to commercial glass.
Florida
Florida has one statewide building code, and it is strict on wind. Here is what it means for storefront, curtain wall and entrance glass.
Texas
Texas mixes state rules with local building codes. Here is what applies to storefront, curtain wall and entrance glass across the state.
California
California has one statewide code, Title 24, updated for 2026 with new limits for commercial glass. Here is what it means for your project.
Rules that apply almost everywhere
Whatever the state, these topics come up on nearly every commercial glass project.
Safety glazing
Model building codes require safety glazing (tempered or laminated glass) in hazardous locations: doors, glass next to doors, large panes near the floor and glass near walking surfaces.
Energy limits
Energy codes cap U-factor (heat loss) and solar heat gain coefficient (SHGC), and limit how much of a wall can be glass. The limits change with climate zone and code edition.
Rated products
Most energy codes expect fenestration with certified, labeled performance ratings, so the inspector can check the glass against the limits.
Accessible entrances
Entrance doors must meet accessibility rules for width, clearances, hardware, opening force and thresholds. A storefront door replacement can trigger this review.
Wind and impact
Coastal and high-wind areas add design pressure and impact rules for glass and frames. Florida and coastal Texas have the strictest programs.
Permits
Replacing a storefront system, adding an entrance or changing an opening usually needs a permit. A glass-only repair in an existing frame often does not. The local building department decides.
Commercial glass regulations: FAQ
Who decides which building code applies to my project?
The building department that issues your permit. Some states adopt one code statewide (California, Florida), while others leave it to each city or county (Arizona, Texas, Illinois).
Do I need a permit to replace storefront glass?
Replacing a storefront system, adding an entrance or changing an opening usually needs a permit. A glass-only repair in an existing frame often does not. Ask the local building department.
How current is this information?
Each page shows the date it was last reviewed (most recently October 29, 2026) and links to the official sources. Codes change on a regular cycle, so always confirm with the building department.
This section is general information, not legal or design advice. Confirm the rules for your project with the local building department and your design professional.
Have a commercial glass project coming up?
Tell us where the building is and what you need. We will help you work out the code questions and the next step.


